Pular para o conteúdo

P2428 Alta Genérico / SAE

P2428: Temperatura dos gases de escapamento — muito alta, banco 1

WhatsApp Telegram X E-mail

Não continue dirigindo

Reduce speed, avoid heavy load, and get this looked at promptly rather than finishing the journey as planned. Exhaust temperature above design melts particulate filter substrates and damages turbochargers, and those are expensive parts that fail quickly rather than gradually. Do not park over dry grass or leaves — an over-temperature exhaust is a genuine fire risk, which is why handbooks warn about this after a filter regeneration. If a burning smell or visible smoke appears, stop somewhere clear and safe. The cause is usually something upstream putting fuel where it should not burn, such as a misfire or a regeneration that never completes, so ask what else is stored alongside it.

O que este código significa

Exhaust gas temperature on bank 1 has exceeded what the module will accept. This is one of the few emissions codes that is about immediate physical risk rather than about compliance.

What is at stake. Modern aftertreatment runs hot by design — a particulate filter regenerating deliberately raises exhaust temperature to several hundred degrees to burn accumulated soot. That is normal. What this code reports is temperature beyond even that, and the things it damages are expensive and quick:

  • The particulate filter substrate can melt or crack, which is a large bill and cannot be cleaned out afterwards.
  • The catalyst can sinter, losing its surface area permanently.
  • A turbocharger sitting in that gas stream is being cooked along with everything else.
  • There is a genuine fire risk. Vehicle handbooks warn against parking over dry grass or leaves during or shortly after a regeneration for exactly this reason, and an exhaust already running above its design temperature makes that warning more pressing rather than less.

The usual causes are upstream and are about fuel arriving where it should not burn:

  • A regeneration running too long or too often, because the filter is not clearing — so the underlying fault is the filter or the sensor watching it.
  • A misfire, dumping raw fuel into a hot exhaust where it burns outside the cylinder. This is the same mechanism that makes a flashing engine light mean stop.
  • Late or excessive injection, including a leaking injector.
  • A faulty temperature sensor, which is the harmless explanation and should be confirmed rather than assumed.

Marked not to be driven because unlike most emissions faults, continuing costs components rather than compliance — and the damage accrues under load, which is precisely when people press on.

Causas prováveis

Comece aqui

Menos comum

Sintomas

Componentes envolvidos

Informação, não instrução

O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.

Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.

Experiência da comunidade

Seja o primeiro a documentar isto

Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.

O que faz valer a leitura:

  • O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
  • O que você mediu, não só o que trocou.
  • O que realmente resolveu — ou que nada resolveu, o que também vale saber.

Entrar ou criar uma conta para adicionar o que você descobriu sobre P2428.