C0076: PWM-Signal der Antriebsschlupfregelung
Was zu tun ist
The ordinary brakes are unaffected — what has switched off is the system that catches a skid for you. The car will feel completely normal until the moment it would have intervened, which is exactly when you will not want it missing. Drive gently in the wet and cold and get it diagnosed.
Was dieser Code bedeutet
The pulse-width modulated traction control output has a fault.
This is the chassis module talking to another module through a varying signal rather than a network message.
Pulse-width modulation carries a number on a single wire. The signal switches on and off rapidly and the proportion of time it spends on is the value — so one wire can say "reduce torque by this much" continuously, with no protocol involved.
It is the older way of doing what C0073 and C0074 do over the bus, and it survives on vehicles where the two modules were never designed to converse, and as a fallback path.
Because it is one wire, it fails like one wire. An open, a short, or a corroded pin puts the duty cycle somewhere the receiver reads as a valid number — which is the danger: a fault here can be a plausible wrong value rather than an obvious absence.
The most important thing first: the car still stops.
ABS, traction control and stability control are all additions to a braking system that works without them. When the module finds a fault it switches itself off and hands back a conventional, fully hydraulic brake system — the pedal, the master cylinder, the lines and the calipers are untouched. You have not lost your brakes.
What you have lost is the help. Without ABS the wheels can lock under hard braking, which lengthens the stopping distance on a slippery surface and — the part people forget — takes away your ability to steer while braking hard, because a locked wheel cannot generate cornering force. Without stability control the car will not catch a slide for you.
So drive it, but drive it as though it were forty years old: brake earlier, leave more room, and be especially careful in rain, snow and on gravel.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · Fachwerkstatt
- Kabelbaum beschädigt · Fachwerkstatt
- Leitungsbruch in der Sensorleitung · Fachwerkstatt
Seltener
- ESP-Steuergerät defekt · Fachwerkstatt
- Leitung mit Masse kurzgeschlossen · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu C0076.