P06BE: Glühkerze von Zylinder 6 — Stromkreis, Bereich/Funktion
Was zu tun ist
Ask for all six plugs to be assessed and make the decision once. They are the same age, access on a six-cylinder engine is usually poor, and removing a glow plug carries a genuine risk of it snapping off in the cylinder head — a risk and a labour bill worth incurring once rather than repeatedly.
Ask for a voltage drop test on the supply under load. This is the last plug on the run, so it feels the accumulated resistance of every connection before it.
Expect hard starting, white smoke and a rough first minute on cold mornings, worsening as the weather cools.
Mention if the plugs have been replaced before and whether they were original parts.
Was dieser Code bedeutet
Cylinder 6's glow plug circuit is electrically valid but not behaving correctly.
This completes the range/performance set, and it is a reasonable place to summarise how the two glow plug families in this block differ — because the corpus carries both and they are diagnosed differently.
The control circuit codes — P066A, P066C, P066E, P067A — are about the drive to the plug. Low means a short to ground or a failed element; they are electrical faults with electrical causes.
The range/performance codes — P06B9 to P06BE — are about resistance, and therefore about temperature. They catch a plug that still works and no longer heats predictably, which makes them the earlier warning of the two.
A car showing range/performance codes has plugs on the way out. A car showing control circuit codes has one that has arrived.
For this code specifically, on a six-cylinder engine, the last plug on the supply run is where accumulated resistance shows up, so measure the voltage drop under load before condemning the plug.
And make the set decision deliberately. Six plugs, poor access, plugs of the same age, and a real risk of one snapping off in the head — all four facts point the same way, and discovering them one at a time over three visits is the expensive path.
Wahrscheinliche Ursachen
Hier anfangen
- Glühkerze ausgefallen · mittel
- Hoher Widerstand in der Sensorleitung · mittel
- Korrodierter oder loser Stecker · einfach
Seltener
- Versorgungsleitung der Glühkerze gebrochen · mittel
- Glühzeitsteuergerät ausgefallen · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P06BE.