P0E1E: Kühlmittelpumpe B des Batteriepakets — Steuerstromkreis, Strom oder Temperatur der Endstufe zu hoch
Was zu tun ist
The car will drive. Expect slower charging and reduced power in hot weather. Ask for what the circuit drives to be tested before the control module is replaced — the module is usually protecting itself from a failing pump or a seized valve, and a new module will report the same fault.
Was dieser Code bedeutet
The module's output driver for the second battery coolant pump has exceeded its current or temperature limit.
This code is about the module's output stage rather than about the thing it drives, and that distinction is the whole of its diagnostic value.
A control module does not switch a pump or a valve with a mechanical relay; it does it with a semiconductor driver built into the module. That driver has its own current and thermal limits, and this family of codes is the driver reporting that it reached them.
Which means the module is protecting itself from the load, and the load is usually the fault. A motor with worn bearings, a valve seizing, a partially shorted winding, or a chafed wire touching earth all draw more current than the driver will pass — so the module shuts the output down and stores this rather than a fault against the component.
The trap is reading it as a module failure. A car that stores a driver current code and gets a new control module will usually store it again within days, because the excessive load is still connected. Measure what the output is driving before condemning what is driving it — and note that the reverse also happens, since a genuinely failed driver stores the same code with a healthy load on the end of it.
On a pump the commonest excessive load is worn bearings or a blockage. A pump forcing coolant through a restriction, or one whose bearings are dragging, draws steadily more current as it deteriorates — which is why this can be an early warning rather than a failure, if it is read as one.
Wahrscheinliche Ursachen
Hier anfangen
- Kühlmittelpumpe des Wechselrichters defekt · Fachwerkstatt
- Kabelbaum beschädigt · Fachwerkstatt
- Korrodierter oder loser Stecker · Fachwerkstatt
Seltener
- Endstufe des Steuergeräts defekt · Fachwerkstatt
- Kühlmittelstrom eingeschränkt oder Kanal verstopft · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P0E1E.