P2A55: Austrittstemperatursensor des Verdampfers B für alternativen Kraftstoff — Stromkreis
Was zu tun ist
The car will usually stay on petrol, or take much longer than usual to switch to gas. Nothing is dangerous and the car drives normally. Before suspecting the gas system, mention whether the heater takes a long time to get warm — a thermostat stuck open delays changeover and is a common, cheap cause.
Was dieser Code bedeutet
The circuit for the outlet temperature sensor on gaseous fuel vaporizer B is faulty.
The vaporizer is the part of a gas system with no petrol equivalent at all, and understanding it explains most of how a bi-fuel car behaves.
LPG leaves the tank as a liquid and has to reach the injectors as a gas. The vaporizer — installers usually call it the reducer — drops the pressure and lets the liquid boil off. And boiling absorbs heat: the same physics that makes a gas cylinder frost over when you draw from it hard. Left alone, a vaporizer would freeze itself solid within a minute and stop working.
So it is plumbed into the engine's coolant circuit. Engine heat replaces the heat that vaporisation removes. That single fact explains the whole starting sequence — the car runs on petrol until the coolant is warm, because until then the vaporizer cannot produce gas, and it is why a bi-fuel conversion always has hoses running to what looks like a small radiator on the bulkhead.
This sensor measures the temperature of the gas leaving it, and it is doing two jobs. It is the changeover permission — too cold and the system stays on petrol. And it is the fuel-density input, because the mass of gas in a given volume depends on temperature, so the injector timing depends on this reading.
Which is why the failure most often shows up as a car that will not change over, and why the diagnosis so often ends in the cooling system rather than the gas system. A thermostat stuck open delays every changeover on every journey while producing no other complaint anyone connects to it.
A second and third vaporizer means a system large enough to need them — a commercial conversion, a large engine, or one tank feeding through more than one reducer. Losing one is a partial failure, so the car still changes over and simply cannot deliver full power on gas, which reads as a vague loss of performance rather than as a fault.
The base circuit fault: no plausible signal.
Wahrscheinliche Ursachen
Hier anfangen
- Verdampfer für alternativen Kraftstoff defekt · Fachwerkstatt
- Korrodierter oder loser Stecker · Fachwerkstatt
Seltener
- Leitungsbruch in der Sensorleitung · Fachwerkstatt
- Thermostat hängt offen · mittel
- Kabelbaum beschädigt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2A55.