P24DA: Fijnstofsensor — fout in uitlaatgasmonster, bank 1
Wat te doen
Mention any recent exhaust work first — this code usually follows it. It says the sensor is not seeing a proper sample of the exhaust gas, and the commonest reason is a sensor not refitted quite right after a repair. That is a free fix if it is found before a new part is ordered.
Listen for a blowing or ticking noise from underneath, especially when cold. An exhaust leak ahead of the sensor lets air in and produces this fault with a perfectly good sensor — and it is worth reporting because it is easy to overlook on a ramp.
The car will drive normally. It is the emissions self-check that is affected, so allow time before an MOT.
Wat deze code betekent
The particulate matter sensor is not receiving a representative sample of the exhaust gas.
This is a mechanical code wearing electrical clothing, and reading it correctly saves a wasted part. The sensor is working. Its heater works, its circuits are sound, its temperature channel is fine. What it is measuring is not the exhaust.
The sensor has to sit in the flowing gas stream to see what is in it. Its element protrudes into the pipe behind a protective shield, and anything that stops representative gas reaching that element produces this code.
- Incorrect installation — a sensor not seated to depth, or rotated so its shield openings face the wrong way, sits in still gas rather than moving gas.
- A blocked or crushed protective shield, which is easy to damage on refitting and blocks the sample without looking obviously wrong.
- An exhaust leak upstream, which lets the pipe draw air in and dilutes what reaches the sensor.
- Soot or condensate bridging the shield, which is a slow accumulation rather than a failure.
Almost every one of these is a consequence of recent work on the exhaust. Ask what was done and by whom before ordering anything, because a sensor refitted correctly resolves a large share of these at no parts cost.
Where nothing has been touched, look for the leak. A blowing joint or a corroded pipe upstream of the sensor is the usual finding on an untouched vehicle.
Waarschijnlijke oorzaken
Begin hier
- Sensor verkeerd geplaatst na de reparatie · eenvoudig
- Uitlaatlek stroomopwaarts van de sensor · gemiddeld
- Sensor niet correct teruggeplaatst na een filtervervanging · eenvoudig
Minder vaak
- Roetvervuiling in de sensoropening · eenvoudig
- Fijnstofsensor defect · gemiddeld
Symptomen
Betrokken onderdelen
Informatie, geen instructie
CarGeek is een naslagwerk, geen werkplaatshandboek. De pagina's zijn geschreven op basis van openbare bronnen en van wat anderen hebben ondervonden, nooit op basis van de servicedocumentatie van de fabrikant zelf, dus ze kunnen onjuist of onvolledig zijn voor jouw specifieke voertuig. Een deel van wat erin staat brengt echt gevaar met zich mee: hoogspanning, brandstof onder druk, opgeslagen energie en hete of bewegende delen.
Laat alles waarnaar je wilt handelen eerst controleren door iemand met een technische opleiding, aan de hand van de eigen procedure van de fabrikant voor jouw voertuig. Niets hier vervangt die procedure.
Ervaring uit de community
Wees de eerste die dit beschrijft
Hierover is nog niets geplaatst. Wat je ook hebt gevonden, het is het opschrijven waard — zelfs een doodlopend spoor bespaart iemand dezelfde middag.
Wat het de moeite waard maakt:
- De auto — merk, model, bouwjaar en motor. Dezelfde storing gedraagt zich per auto anders.
- Wat je gemeten hebt, niet alleen wat je vervangen hebt.
- Wat het echt verholpen heeft — of dat niets dat deed, wat ook nuttig is om te weten.
Inloggen of een account aanmaken om toe te voegen wat je hebt gevonden over P24DA.