P0C50: Sensor de posição do motor de tração A — circuito A
O que fazer
Losing one channel of a resolver loses the angle completely — the two channels are halves of one measurement, not a spare. Expect electric drive to be cut rather than reduced. Before a sensor is replaced, ask whether the wiring and its shielding were checked: these are low-level analogue signals and a resistive joint or a disturbed screen produces exactly this. Nothing here is a home job.
O que este código significa
Channel A of the position sensor on drive motor a has a circuit fault.
Two things need separating before this makes sense, and the corpus carries both.
First, this is not the same code as P0A3F. That one names the position sensor as a whole; these name its individual channels. The same shape as the current sensors at P0BE5 — a whole-thing code beside per-channel codes — and the same trap if they are read as duplicates.
Second, and this is the good part: channel A and channel B are not two sensors, and they are not redundant. A resolver reports rotor angle as two signals — one proportional to the sine of the angle, one to the cosine. Either alone is ambiguous: a sine value of one half is consistent with thirty degrees and with a hundred and fifty. Only the two together give a unique angle. So losing one channel does not degrade the measurement, it destroys it, and the inverter has no idea where the rotor is.
And the pair carries a self-check that costs nothing, which is the third time this block has used the trick. Sine squared plus cosine squared equals one, at every angle, always. So the module can verify its own position measurement against a mathematical identity — exactly as it sums the three phase currents to zero at P0BFD, and checks the planetary speed equation at P0C2F. When the sum of squares drifts away from one, something is wrong with a channel even though both signals still look like plausible waveforms.
That is what most Range/Performance faults in this family are: not a dead channel, but a channel whose amplitude has drifted, usually because a connection has gone resistive or shielding has been disturbed.
Causas prováveis
Comece aqui
- Sensor de posição do motor elétrico com defeito · especializado
- Conector corroído ou frouxo · fácil
Menos comum
- Chicote gasto por atrito entre a transmissão e o inversor · especializado
- Alimentação de tensão de referência do sensor inoperante · moderado
- Sensor de posição do motor mal montado ou desalinhado · especializado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P0C50.