P2589: Sensor B de posição do controle de sobrealimentação do turbocompressor — circuito alto
O que fazer
The engine will feel flat, possibly with a reduced power warning.
If any work has recently been done around either turbocharger, the exhaust gas recirculation valve or the manifold, say so straight away. This connector is regularly unplugged to reach those parts and is easy to leave off in a space nobody can see into. That check is free.
And one that is specific to a car with two turbochargers: if both sides were disturbed, ask for it to be confirmed that the two position sensor plugs have not been swapped. They are often the same connector, so nothing stops each being fitted to the other sensor, and everything looks perfectly assembled afterwards. The codes that result blame parts that are in good condition.
O que este código significa
The second turbocharger's vane position circuit reads above its valid range — an open circuit, a disconnected connector, or a short to supply.
The outcome matches P2588: no trustworthy feedback, so no closed-loop control of that turbocharger, so a default vane position and a flat engine.
The free thing to eliminate first is a disconnected plug, for the reason given at P2565 — this connector is routinely unplugged to reach the turbocharger, the exhaust gas recirculation valve or the manifold, and it sits in a tight, hot space that cannot be inspected without a mirror.
On a twin-turbo engine there is a second version of that mistake, and it is worth naming because it is invisible: the two connectors can be swapped. The A and B sensors are frequently the same part with the same plug, so after work that disturbed both there is nothing physical to prevent each being reconnected to the other's sensor. Everything looks correctly assembled. The module then reads each turbocharger's position through the other's circuit, and the codes that follow point confidently at hardware that is perfectly good. If both sides were disturbed, confirming which loom goes where is worth doing before any part is bought.
Causas prováveis
Comece aqui
- Conector do sensor desconectado · fácil
- Circuito aberto na fiação do sensor · moderado
- Sensor de posição das palhetas do turbo com defeito · moderado
Menos comum
- Conectores dos sensores trocados no reparo · fácil
- Dano térmico ao sensor ou à fiação · moderado
- Fiação em curto com a tensão · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P2589.