P04DA: Regelung der Abgasrückführung im geschlossenen Regelkreis an der Grenze — Durchfluss zu hoch
Was zu tun ist
Say whether the engine idles roughly, hesitates when pulling away, or has stalled. Those are the classic symptoms of too much recirculated exhaust at low load and they help confirm the diagnosis.
Ask for the EGR valve seat to be inspected and cleaned. Carbon on the seat stops the valve closing fully — it reports closed while it is not — and cleaning is far cheaper than replacement.
Mention any recent EGR work, since a gasket not seated correctly lets gas past the valve entirely and produces this.
Do not leave it long. Excess recirculation makes the engine produce much more soot, which blocks the particulate filter faster — so a modest repair now avoids a considerably larger one.
Was dieser Code bedeutet
The module has closed the EGR valve as far as it is permitted to and flow is still too high.
This is the mirror of its sibling and the more noticeable of the two from the driver's seat, because excess recirculated gas at low load is what makes an engine run badly.
Recirculated exhaust is inert — it does not burn. At full throttle a proportion of it is exactly what the engine wants; at idle and light load it displaces the oxygen needed for stable combustion. So too much flow produces a rough, hunting idle, hesitation pulling away, black smoke and, at the extreme, a stall.
The valve not closing is the cause almost every time, and there are three ways that happens:
- Carbon on the seat. Deposits build until the pintle cannot seat fully — the valve is commanded closed, reports closed, and is not.
- A broken or weak return spring, so the valve rests part-open.
- A cooler bypass or second EGR path stuck open, letting gas through a route the valve does not control.
A wrongly seated EGR gasket does the same and is worth checking after any recent EGR work, since it lets gas past the valve entirely.
The important consequence is soot. Excess EGR at low load makes the engine produce far more particulate matter, which loads the diesel particulate filter faster than it can clear itself — so this code left alone tends to produce filter codes as well.
Wahrscheinliche Ursachen
Hier anfangen
- Rußablagerungen im AGR-System · mittel
- AGR-Ventil hängt oder ist festgefressen · mittel
Seltener
- Rückstellfeder des Ventils gebrochen · mittel
- Bypassklappe des AGR-Kühlers festgefressen · mittel
- AGR-Dichtung oder -Flansch undicht · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P04DA.