P20E8: AdBlue-Druck zu niedrig
Was zu tun ist
Look under the vehicle for white crystalline deposits around the reductant lines and connections. Reductant dries to a distinctive white crust, and finding it means a leak — which is both the easiest cause to confirm and useful to report before diagnosis starts.
Mention the weather. In cold conditions, partly frozen fluid produces low pressure with nothing actually broken — in which case the real fault is a heater, not the pump.
Mention roughly how often you top the tank up and whether that has changed, since a leak shows up as increased consumption.
Do not leave it. The system is under-dosing without any symptom you can feel, and the emissions sequence escalates towards a speed limit and eventually a restart lockout.
Was dieser Code bedeutet
The reductant system cannot reach the pressure it needs to dose accurately.
Pressure is what turns an injector opening time into a known quantity of fluid. The pump holds the line at several bar; the module then meters by how long the injector opens. If pressure is low, every dose is smaller than the module believes — so the system under-doses while thinking it is doing the right thing, and NOx output rises without any obvious symptom.
The causes fall into three groups, and they are separated by when the fault appears.
- A restriction on the supply side — a blocked filter, a crystallised line, or a pump strainer clogged with deposits. This worsens gradually.
- A leak. Reductant escaping between pump and injector, which leaves the unmistakable white crystalline residue that makes this the easiest cause to confirm by looking.
- A pump that can no longer build pressure, from wear or from crystallisation inside it.
Cold weather deserves separate consideration and is the seasonal answer. Partially frozen fluid, or slush in the lines, produces low pressure with entirely sound hardware — so a low-pressure code in winter should prompt a check of the heater circuits before anything is replaced.
Look underneath for white deposits before anything is dismantled. It takes a minute and it either finds the fault or rules out the easiest cause.
Wahrscheinliche Ursachen
Hier anfangen
- AdBlue-Leckage aus Tank oder Leitungen · mittel
- AdBlue-Filter verstopft · mittel
- AdBlue-Pumpe defekt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P20E8.