U0103: Kommunikationsverlust mit dem Steuergerät A der Gangschaltung
Was zu tun ist
The car will hold whichever gear it is in and may refuse to accept a new selection.
Take the parking situation seriously if this is a car with a small lever, dial or buttons rather than a traditional gearstick. On those, park is not a mechanical position you push the lever into — it is a request that an actuator carries out — so it may not engage when you expect it to. Use the parking brake every time you leave it, and check the dashboard actually shows P before you get out. On a slope, apply the parking brake before releasing the footbrake.
Get it recovered rather than driven far. As with all network codes, this rarely means the module itself has failed — its wiring, its connector and its power supply come first.
Was dieser Code bedeutet
The gear shift module has stopped being heard from. The general reasoning is at U0100.
On a shift-by-wire vehicle this module is the only thing that knows what the driver asked for, because there is no mechanical link between the selector and the gearbox — the point made at P0820, and its consequence arrives here in full. The lever, dial or buttons report to this module, and the module tells the transmission. Break that conversation and the request never reaches anything.
So the vehicle holds the gear it is in and will not accept a new selection, including park. That is worth stating plainly: park is an actuator carrying out a request, not a mechanical fact, so a vehicle that cannot be shifted out of drive also may not reliably go into park when the driver expects.
The parking brake is mechanically independent on most vehicles and is the thing to rely on, which is the same practical advice P0820 gives and the reason it is repeated here.
On vehicles with a conventional mechanical lever the consequences are milder — the gearbox still receives the lever's position through the transmission range sensor — and the complaint is usually a display showing the wrong gear or refusing to allow manual mode.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · einfach
- Datenbusleitungen beschädigt · mittel
- Versorgung oder Masse des Steuergeräts ausgefallen · mittel
Seltener
- Wasser in den Stecker eingedrungen · mittel
- Schaltsteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0103.