U0231: Kommunikationsverlust mit dem Regensensormodul
Was zu tun ist
The car drives normally, but automatic wipers will not work — and on most vehicles the automatic headlights share this module, so they may stop coming on at dusk. That is the part to watch, because from a lit cabin it is genuinely easy not to notice you are driving unlit. Use the wipers and lights manually until it is fixed.
Two free things to check first. Make sure the wiper stalk is actually in its AUTO position — knocked out of it, the symptom is identical. And if the windscreen has been replaced recently, say so: the sensor works by shining light into the glass, so it needs a clear gel pad coupling it to the screen, and a screen fitted without a new pad, or with an air bubble under it, gives exactly this complaint. That job also disturbs the connector.
Was dieser Code bedeutet
The rain sensing module has stopped being heard from. See U0200 for the block's framing.
A rain sensor is an optical device, not a moisture detector, and knowing that explains its whole failure pattern. It sits against the inside of the windscreen behind the mirror and shines infrared light into the glass at an angle that makes it reflect internally. Dry glass returns nearly all of it; water on the outside surface lets some escape, and the drop in returned light is the measurement.
Everything therefore depends on the sensor being optically coupled to the glass, which is done with a clear gel pad or adhesive lens. The commonest complaint is not a network fault at all but that coupling failing: an air bubble, a gel pad that has aged and lifted at one edge, or a sensor refitted without a new pad after a windscreen replacement. Any rain-sensor problem following a windscreen change is that until proven otherwise, and the same job frequently disturbs the connector.
With the module unavailable the wipers fall back to manual control, which is a genuine safety consideration rather than merely an inconvenience: a driver who has become used to automatic wipers will not be reaching for the stalk. Automatic headlights very often share this module too, so they may stop switching on at dusk — and that is the more dangerous half, because driving unlit at dusk is easy not to notice from inside a lit cabin.
Worth eliminating first, because it is free: many vehicles disable automatic wiping unless the stalk is in the AUTO position, and a stalk knocked out of that position produces an identical complaint.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · einfach
- Sensorstecker abgezogen · einfach
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0231.