U0406: Ungültige Daten vom Steuergerät der Einspritzventile empfangen
Was zu tun ist
Expect reduced power and possibly a limited rev range, along with rough running.
This module drives the injectors and reports back whether each injection actually happened as asked. When that report stops making sense, the engine deliberately holds back rather than fuelling on information it cannot verify — so the lack of power is protection.
The fault is often a single injector rather than the module. These modules report on each injector separately, and one shorted or open injector is enough to make the whole report unacceptable. Ask for the injectors and their wiring to be tested individually before the module is replaced.
Two other things worth raising. If injectors have been replaced recently, ask whether their calibration codes were programmed — see P2690, because uncoded injectors produce feedback that does not add up. And ask for the module's mounting and heat sink to be checked: these run hot, and unlike most modules on the car, heat damage is a genuine cause here.
Was dieser Code bedeutet
The fuel injector control module is broadcasting data that cannot be accepted as true. See U0400 for the family's framing.
A separate injector control module exists where the injectors need drive electronics the engine module cannot provide directly — most commonly on diesels with piezo injectors, which require high voltages and precisely shaped pulses, and on some engines with hydraulically actuated injection.
What it reports back is the substance of this code: confirmation that each injection actually happened as commanded — the timing achieved, the current delivered, and whether any channel faulted. The engine module needs that feedback because it is fuelling on the assumption that its commands were carried out.
An implausible report therefore breaks a loop that matters. The engine module cannot verify what was injected, and its response is to derate — reduced power, sometimes a limited rev range — because continuing to fuel confidently on unverified feedback is the thing it must not do.
As with the rest of this family, look past the module. Injector control modules report per-channel results, and a single shorted or open injector is enough to make the whole report unacceptable — which the corpus already describes as one injector dragging a driver down. So the fault is frequently one injector or its wiring, not the module.
One thing specific to these systems and worth asking about: heat. These modules dissipate real power and are often mounted on the engine or in the engine bay with a heat sink. A module that has been cooking gradually is a genuine failure mode here — unlike most of the modules in this family — so its mounting, its heat sink contact and any thermal paste are worth inspecting rather than assumed.
And the calibration point from P2690 applies: injectors carry individual codes, and a set fitted without them produces feedback the module cannot reconcile.
Wahrscheinliche Ursachen
Hier anfangen
- Kurzgeschlossener Injektor zieht die Endstufe herunter · mittel
- Steuergerät der Einspritzventile ausgefallen · Fachwerkstatt
- Kabelbaum der Einspritzventile beschädigt · mittel
- Hitzeschaden an Sensor oder Leitung · mittel
- Korrodierter oder loser Stecker · einfach
Seltener
- Injektor ohne Eingabe seines Kalibrierwerts eingebaut · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0406.