P218F: Aucun débit AdBlue détecté
Que faire
Check the reductant tank level yourself first, and say when it was last filled. It sounds obvious, but a level sensor reporting fluid that is not actually there produces exactly this fault.
Mention the weather. In cold conditions this is very often frozen fluid rather than a failed part — the fluid freezes at about −11°C — and the real fault is then a heater rather than anything in the dosing system.
Ask whether the injector can be cleaned rather than replaced. The usual cause is dried reductant blocking it, that dissolves in warm water, and the part is expensive.
Do not leave it. With nothing being dosed, the emissions system escalates towards limiting your speed and eventually refusing to restart the engine.
Ce que signifie ce code
The system commanded reductant dosing and detected none leaving.
This is the bluntest code in the reductant family and it is the easiest to read: the module asked for fluid and nothing moved. Not too little — none.
That absoluteness narrows the causes usefully, because a partial restriction produces a pressure or consumption code instead. No flow at all means the path is completely closed somewhere, and there are only a handful of places it can be.
- A crystallised injector, jammed shut by dried urea deposits. This is the commonest cause by some margin.
- Frozen fluid, which is the seasonal answer and points at a heater fault rather than a dosing one. In cold weather, check the heater circuits before touching the dosing hardware.
- A blocked filter or a pump that is not running.
- An empty tank, which sounds obvious and is worth confirming rather than assuming — a level sensor reporting fluid that is not there produces exactly this.
The consequence is immediate and legally mandated. With no reductant reaching the exhaust, nitrogen oxide output is entirely uncontrolled, so the vehicle begins the inducement sequence — warnings, then a speed limit, then a refusal to restart.
Ask whether the injector can be cleaned rather than replaced. Urea deposits dissolve in warm water, and these are not cheap parts.
Causes probables
Commencez ici
- Injecteur d'AdBlue cristallisé · modérée
- AdBlue gelé dans le réservoir ou les conduites · modérée
- Filtre d'AdBlue obstrué · modérée
Moins fréquent
- Pompe d'AdBlue défectueuse · modérée
- Réservoir d'AdBlue vide ou mal rempli · facile
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P218F.