P2518: Kältemitteldrucksensor B — Stromkreis hoch
Was zu tun ist
Expect the air conditioning to stop working — the module is disengaging the compressor to protect it. Look at the front of the condenser for leaves, insect debris or road dirt, and check the cooling fans run when the air conditioning is switched on; both are free and both cause genuinely high pressure. If the system has been topped up from a canister, say so. Refrigerant is specified by weight and an overfilled system cools worse, not better, while running at pressures the parts were not designed for.
Was dieser Code bedeutet
The second refrigerant pressure sensor circuit reads above its valid range — an open circuit, a disconnected sensor, or a genuinely over-pressured system.
That last case is worth separating from the wiring ones, because it is a real condition with a real cause and the module's response to it is protective. High refrigerant pressure means the system cannot reject its heat, and the compressor is disengaged to stop it damaging itself or bursting a hose. The reasons are mostly physical and mostly visible: a condenser blocked with leaves, insects or road debris, cooling fans that are not running, or a system that has simply been overfilled.
Overfilling deserves naming because it is self-inflicted and increasingly common. The refrigerant charge is specified by weight to within a few tens of grams, and topping up from a canister without weighing what goes in is guesswork. An overcharged system cools worse than a correctly charged one, not better, and it runs at pressures the components were not designed for.
So the checks before the sensor: look at the condenser, confirm the fans run with the air conditioning on, and ask whether the system has been topped up rather than properly evacuated and recharged.
Wahrscheinliche Ursachen
Hier anfangen
- Leitungsbruch in der Sensorleitung · mittel
- Kondensator verstopft oder eingeengt · mittel
- Kältemittelsystem überfüllt · mittel
- Kühlerlüfter laufen nicht · mittel
Seltener
- Kältemitteldrucksensor defekt · einfach
- Korrodierter oder loser Stecker · einfach
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2518.