U0240: Kommunikationsverlust mit dem Einklemmschutz-Steuergerät B
Was zu tun ist
The car drives normally. Powered closures will lose their unattended operation and move only while a switch is held.
On a vehicle with powered sliding doors or a powered tailgate, take this seriously rather than treating it as a lost convenience. This module supervises the protection that stops a heavy powered door closing on somebody — and unlike a window, those close on an opening people walk through. If children use those doors, supervise them until it is fixed.
If this followed a battery change or a flat battery, the closures may just need re-initialising — see U0239, it is free and often the whole fix.
Otherwise the wiring is the usual suspect, and on a sliding door especially: its loom travels the whole length of the door's track every time it opens, which is much harder on wiring than any hinged door.
Was dieser Code bedeutet
The second entrapment control module has stopped being heard from. The function and the protective-restriction reasoning are at U0239.
A second entrapment module means the vehicle has enough powered closures to need the supervision split, which in practice means a large vehicle: powered sliding doors, a powered tailgate, multiple roof panels, or rear closures on a van or people carrier.
That population changes the risk rather than the diagnosis, and it is the reason this page exists separately. A window closing on a finger is painful. A powered sliding door has the mass and the leverage to do considerably more harm, and it closes on an opening that people walk through rather than reach into — which is precisely why these vehicles carry more entrapment supervision, not less.
So the advice to treat the lost protection seriously is stronger here. Where the affected closure is a sliding door or a tailgate, and it can still be operated at all, it should be treated as an unsupervised mechanism until it is fixed — worth knowing on a family vehicle where children use those doors.
Diagnostically, the pattern check from U0202 applies: one entrapment module silent while the other reports normally localises the fault to that module's own branch, while both going quiet together points at a shared supply or the gateway.
The sliding-door harness caution from U0203 applies to anything this module supervises on such a door — the loom travels the full length of a track and is the harshest wiring environment in the block.
Wahrscheinliche Ursachen
Hier anfangen
- Leitungsbruch in der Türkabeldurchführung · mittel
- Batterie abgeklemmt oder Steuergerät neu programmiert · einfach
- Kabelbaum beschädigt · mittel
- Korrodierter oder loser Stecker · einfach
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0240.