Naar de inhoud

P04D0 Gemiddeld Generiek / SAE

P04D0: Temperatuursensor C van de uitlaatgasrecirculatie — circuit laag

WhatsApp Telegram X E-mail

Wat te doen

Ask for the wiring near the exhaust and EGR cooler to be inspected before the sensor is replaced. On this kind of sensor a short to earth reads exactly like an impossibly hot sensor, and a wire chafed against a hot pipe is the usual cause — much cheaper than a part.

Mention if the fault comes and goes with the weather. Appearing in the wet and clearing when dry points firmly at water in a connector.

Ask which part of the system this third sensor watches on your engine, since it varies and the answer decides where the garage looks.

The car will usually drive normally, but the emissions system will not be working as intended.

Wat deze code betekent

The third EGR temperature sensor's signal is below the lowest voltage the circuit should produce.

A third EGR temperature sensor means a more complex recirculation system than most, and identifying what it watches is the first step. Two arrangements are common: an engine with both high-pressure and low-pressure EGR, where each path is monitored separately, or a V engine with a cooler per bank.

On these thermistor circuits, low voltage means the opposite of what it sounds like. Resistance falls as temperature rises, so a low signal corresponds to a very hot sensor — and a short to ground produces the same reading as an impossibly hot one. They are electrically identical.

So a circuit-low code on a temperature sensor almost always means a short, not heat. Check the wiring before believing the temperature.

Location makes shorts likely here. These sensors and their harnesses run close to the exhaust and the cooler, where insulation hardens and eventually fails against the metal it is resting on. A wire chafed against a hot pipe is the classic finding.

Water in the connector does the same thing and is why the fault often appears in wet weather and clears in dry.

Unplugging the sensor separates wiring from element in a minute: a circuit that stays low with the sensor disconnected is a harness fault.

Waarschijnlijke oorzaken

Begin hier

Minder vaak

Symptomen

Betrokken onderdelen

Informatie, geen instructie

CarGeek is een naslagwerk, geen werkplaatshandboek. De pagina's zijn geschreven op basis van openbare bronnen en van wat anderen hebben ondervonden, nooit op basis van de servicedocumentatie van de fabrikant zelf, dus ze kunnen onjuist of onvolledig zijn voor jouw specifieke voertuig. Een deel van wat erin staat brengt echt gevaar met zich mee: hoogspanning, brandstof onder druk, opgeslagen energie en hete of bewegende delen.

Laat alles waarnaar je wilt handelen eerst controleren door iemand met een technische opleiding, aan de hand van de eigen procedure van de fabrikant voor jouw voertuig. Niets hier vervangt die procedure.

Ervaring uit de community

Wees de eerste die dit beschrijft

Hierover is nog niets geplaatst. Wat je ook hebt gevonden, het is het opschrijven waard — zelfs een doodlopend spoor bespaart iemand dezelfde middag.

Wat het de moeite waard maakt:

  • De auto — merk, model, bouwjaar en motor. Dezelfde storing gedraagt zich per auto anders.
  • Wat je gemeten hebt, niet alleen wat je vervangen hebt.
  • Wat het echt verholpen heeft — of dat niets dat deed, wat ook nuttig is om te weten.

Inloggen of een account aanmaken om toe te voegen wat je hebt gevonden over P04D0.