P0E73: Sinal do piloto de controle — frequência alta
O que fazer
Try a different charge point first — that separates the car from the supply in one test. If it happens everywhere, mention any water ingress or damage around the charging inlet; a noisy pilot signal is very often a poor earth or a wet connector rather than a faulty part.
O que este código significa
The Control Pilot signal's frequency is above specification.
The Control Pilot is a 1 kHz square wave, and the frequency is not decoration — it is how the car knows the signal is a real pilot rather than noise.
The full handshake is at P0CF3. In short: the charge point puts a square wave on one pin, and the pulse width states how much current the car may draw; the car replies by switching resistors to pull the voltage down in defined steps. A charge point will not energise the cable until it sees a valid reply.
The frequency is the carrier that whole conversation rides on, and the standard pins it at 1 kHz precisely so that width can be measured against it. Measuring a pulse width means comparing it against the period — so a frequency that has drifted makes every current limit the car calculates wrong, not merely suspect.
Which is why this code usually means the supply rather than the car. A vehicle measuring an out-of-specification frequency is reporting on the equipment it is plugged into, and the single most useful test is another charge point.
High frequency is rarer and more often the car's measurement than the supply's signal. A charge point's pilot generator is usually crystal-derived and does not drift upward on its own; a car reading it high is frequently reading noise superimposed on the signal rather than a genuinely fast wave.
That points at the pilot conductor's shielding and its earth — a pilot line running alongside a high-current charging cable picks up interference readily, and a degraded earth is what stops that interference being drained away. Water in the inlet does the same thing, which is why this and P0DAA share a cause list.
Causas prováveis
Comece aqui
- Entrada de carga ou pinos danificados · moderado
- Infiltração de água no conector · especializado
- Conector corroído ou frouxo · especializado
Menos comum
- Falha no equipamento de carga externo · fácil
- Conexão de massa corroída · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P0E73.