P2135: Correlação de tensão entre os sensores ou interruptores A e B de posição da borboleta ou do pedal
Não continue dirigindo
The car will be in reduced power or refusing to rev. Before agreeing to a throttle body or pedal assembly — neither is cheap — ask whether the five-volt reference and the ground were measured at the connector. Both sensors share those, so one bad supply makes two good sensors disagree, and that is a much smaller repair. If other unrelated sensors are also faulted, that points the same way.
O que este código significa
Position sensors A and B disagree. This is the code the whole redundancy arrangement exists to produce, and it is among the most commonly misdiagnosed in the P2 range — because the obvious reading of it is wrong more often than it is right.
What it means. Sensors A and B are the deliberately-mismatched pair described under P2104: different slopes, or one rising while the other falls, so that no single fault can move both in a way that still looks consistent. The module compares them continuously. When they disagree beyond tolerance, it knows one of them is lying and — critically — it cannot tell which. So it distrusts both and withdraws throttle authority, which is why P2104 or P2106 usually appears alongside.
Why the obvious reading is wrong. "The sensors disagree, so a sensor is faulty" skips the thing they have in common. Both are fed from the same five-volt reference and share a ground, usually through the same connector. If that reference sags, or the ground develops resistance, both sensors shift at once — and because they have different slopes, they shift by different amounts. The correlation fails. Neither sensor is faulty. The corpus makes this argument at length under P0641 and it applies here exactly.
Why it matters financially. On a throttle body, the two sensors are integral and not separately available, so "replace the sensor" means replacing the whole throttle body. On a pedal, the same is true of the pedal assembly. Neither is cheap, and a five-volt reference fault or a corroded shared connector costs a fraction of either.
So the order is: measure the reference voltage and the ground at the connector, check the connector itself, and only then look at the sensors. If other unrelated sensors are also reporting faults, that is the shared-supply case confirming itself and the sensors here are almost certainly innocent.
Causas prováveis
Comece aqui
- Alimentação de tensão de referência do sensor inoperante · moderado
- Conector corroído ou frouxo · fácil
- Massa do sensor deficiente · moderado
Menos comum
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P2135.