P2603: Kühlmittelpumpe A — Steuerstromkreis hoch
Was zu tun ist
The car will often feel normal. Ask for the pump's own fuse to be checked first — it has a dedicated high-current supply, and a blown fuse looks exactly like a broken wire until someone opens the box. If a new fuse blows straight away, the pump itself has failed and that is worth knowing before more time is spent on wiring.
Meanwhile keep an eye on the temperature gauge in slow traffic, and be aware that on a turbocharged engine the pump normally runs on for a few minutes after switch-off to protect the turbocharger — which is the part of this fault that does harm quietly.
Was dieser Code bedeutet
The coolant pump control circuit reads above its valid range — an open circuit, a disconnected connector, or a short to supply.
The practical result is normally a pump that cannot be commanded, so the consequences are those set out at P2600: reduced cooling capacity at low road speeds, a heater that goes cold whenever a stop-start system shuts the engine down, and — on a turbocharged engine — the loss of the run-on cycle that keeps coolant moving through the turbo bearing housing after shutdown.
The pump's own supply is worth checking before the pump. These run on a dedicated high-current feed with its own fuse, and a blown fuse presents as an open circuit indistinguishable from a broken wire until someone looks. A fuse that blows again immediately afterwards is telling you the pump has failed short, which is useful information rather than a nuisance.
Wahrscheinliche Ursachen
Hier anfangen
- Sicherung durchgebrannt oder Versorgung ausgefallen · einfach
- Leitungsbruch in der Steuerleitung · mittel
- Sensorstecker abgezogen · einfach
- Elektrische Kühlmittelpumpe defekt · mittel
Seltener
- Leitung mit Spannung kurzgeschlossen · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2603.