P2757: Druckregelmagnetventil der Wandlerüberbrückungskupplung — Steuerstromkreis, Funktion oder klemmt ausgeschaltet
Was zu tun ist
The car will usually drive, and the most likely symptom is a shudder at light throttle around 60–80 km/h, plus higher fuel consumption. Check the transmission fluid level and condition — degraded fluid causes a lot of these and a fluid service is the cheap end of the list. Get it looked at before it turns into heat damage.
Was dieser Code bedeutet
The torque converter clutch pressure control solenoid is not applying the clutch as commanded.
The torque converter clutch is what stops an automatic wasting fuel at cruise, and it has to be applied gradually rather than switched on.
A torque converter drives through fluid, which always slips a little — that is what makes an automatic smooth from rest, and it is a permanent efficiency loss once moving. So above a certain speed the converter is locked mechanically, bolting engine to gearbox and removing the slip.
Locking it abruptly would feel like a gear change nobody asked for, so the clutch is applied through a pressure control solenoid that ramps it, and often holds it in controlled slip — deliberately allowing a few tens of revolutions per minute of difference to absorb engine pulses. That is what this solenoid regulates.
Not applying means the converter never locks, so the engine runs a few hundred rpm higher than it should at cruise and fuel consumption rises noticeably. It also means the converter is stirring fluid where it should be driving through it, which puts heat into the transmission.
The shudder worth knowing about: a converter clutch slipping when it should be locked produces a rhythmic vibration at light throttle, most often between about 60 and 80 km/h, which drivers describe as rumble strips or a rough road. It is frequently mistaken for tyres, wheel balance or driveline vibration, and the distinguishing test is that it appears only under gentle acceleration at steady speed and disappears the moment the throttle is lifted or pressed harder.
Fluid condition matters here more than almost anywhere else. Controlled slip depends on the fluid's friction modifiers, which degrade with heat and age — so shudder is very often old fluid rather than a failed part, and a fluid service is the cheap first move.
Transmission fluid is the first thing to check and the thing most often skipped.
It is not a lubricant that also happens to move things — it is the working fluid of a hydraulic machine. It carries the pressure that applies every clutch, it carries the heat away, it lubricates, and it is the friction surface itself: the additive package is tuned so clutches grip smoothly rather than snatching.
So fluid that is low, old, burnt or of the wrong specification changes how the transmission behaves, and it does so before any part has failed. Burnt fluid smells burnt and looks dark; healthy fluid is translucent. Checking it costs nothing and rules out a great deal.
"Filled for life" is a claim about the warranty, not the transmission. Many sealed units have no dipstick and a manufacturer schedule that never changes the fluid, and they still wear out faster on original fluid than on serviced fluid.
Wahrscheinliche Ursachen
Hier anfangen
- Magnetventil der Wandlerüberbrückungskupplung defekt · Fachwerkstatt
- Getriebeöl zu wenig oder verbraucht · mittel
- Abrieb im Getriebeöl · Fachwerkstatt
- Korrodierter oder loser Stecker · Fachwerkstatt
Seltener
- Wandlerüberbrückungskupplung verschlissen · Fachwerkstatt
Selten
- Getriebesteuergerät defekt · Fachwerkstatt
Symptome
- Spürbare Vibration im Fahrzeug
- Motorkontrollleuchte leuchtet
- Motor geht aus
- Harte oder ruckartige Schaltvorgänge
- Kein spürbarer Unterschied im Fahrverhalten
- Unruhig im Gang beim Stehen, ruhig im Leerlauf
- Vibrieren bei konstanter Geschwindigkeit
- Tritt nur über Bodenwellen oder auf schlechter Straße auf
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2757.