Zum Inhalt springen

U0171 Hoch Generisch / SAE

U0171: Kommunikationsverlust mit dem Sensor B des Rückhaltesystems

WhatsApp Telegram X E-Mail

Was zu tun ist

The airbag warning light means the airbags may not deploy correctly. Safe to drive to a garage; it should not be left.

The front crash sensors work as a pair, one on each side of the car's nose. They are not spares for each other — the difference between what the two of them feel is how the car works out whether it has been hit head-on, at an angle, or on one corner, and that decides which airbags fire.

One question is worth asking, because it changes the size of the job: has the other one gone quiet too? Both at once is usually a single break in the wiring they share on the way forward from the airbag computer — one repair, not two. Only one means the problem is on that sensor's own branch, and the search is local.

Mention any front-end work, however minor and however long ago — a bumper off, a headlight, a radiator, a wing. That is where these live.

And if a connector is found corroded, ask for it to be replaced rather than cleaned up. The front of the car is the worst place on it for a connector, and an airbag circuit is not somewhere to accept a patched-up contact.

Was dieser Code bedeutet

A restraints system sensor has stopped being heard from. See U0170 for the one-versus-several rule and U0471 for what these sensors do.

Front crash sensors come in pairs, one on each side of the vehicle's nose, and the pairing is a measurement rather than redundancythe difference between what the left and right sensors feel is how the module works out whether an impact is full-width, offset or a pole strike, which changes which airbags fire and how hard.

For a lost-communication code that produces a specific and useful question: has the other one gone quiet too?

Both silent is not two failures. They share the leg of the loop that runs forward from the restraints module, and often a common connector behind the bumper or at the front crossmember. A single break in that shared run takes both, and it is one repair.

One silent and one reporting is that sensor's own branch, and the search is local.

Either way the front of the vehicle is the worst environment on it for a connector — spray, salt, stone damage, and heat from the engine bay a few centimetres behind. The corpus's standing advice applies: check the connectors before the sensors, and where one is corroded, replace it rather than cleaning it. A restraints circuit is not somewhere to accept a repaired contact.

Wahrscheinliche Ursachen

Hier anfangen

Seltener

Symptome

Beteiligte Bauteile

Information, keine Handlungsanweisung

CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.

Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.

Erfahrungen der Community

Schreiben Sie den ersten Erfahrungsbericht dazu

Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.

Was einen Bericht lesenswert macht:

  • Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
  • Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
  • Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.

Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0171.