P2340: Zylinder 5 — Über der Schwelle des Klopfsensors oder Verbrennungsschwingungssensors
Was zu tun ist
Avoid heavy loads and towing, and ease off if you hear a rattle. On an engine this size, ask for the cooling system to be checked as well as the fuel and injectors — coolant picks up heat as it travels through the block, so cylinders further along run hotter and are the first to knock when cooling is not quite right. Note it if the fault appears in hot weather, in traffic or when towing, since that points the same way. The temperature gauge reading normal does not rule this out.
Was dieser Code bedeutet
Cylinder 5 is requiring more knock protection than normal. The mechanism is at P2336.
A fifth cylinder means a larger engine, and on larger engines cooling is no longer uniform. Coolant enters the block at one end and leaves at the other, picking up heat as it goes, so the cylinders furthest along the flow path run measurably hotter than the first ones. Engine designers compensate for this — but the compensation assumes the cooling system is working as designed.
When it is not, the cylinders that were already the hottest are the ones that cross the knock threshold first. So a knock code on a rear or middle cylinder of a straight-six or a V engine is worth treating as a possible cooling question rather than only a fuel or injector one, particularly if it appears in hot weather, in traffic, or when towing.
The things to look at are ordinary and mostly cheap: coolant level and condition, a thermostat opening late, a radiator partly blocked externally by debris or internally by scale, a water pump whose impeller has eroded, and air trapped in the system after a previous repair.
The temperature gauge is unhelpful here for the reason given at P2181 — it is damped enough to read normal across a wide band — so its sitting in the middle is not evidence that cooling is adequate.
Wahrscheinliche Ursachen
Hier anfangen
- Niedriger Kühlmittelstand · einfach
- Falscher Kraftstoff oder zu niedrige Oktanzahl · einfach
Seltener
- Kühler verstopft oder eingeengt · mittel
- Thermostat öffnet zu spät · mittel
- Wasserpumpe defekt · Fachwerkstatt
- Rußablagerungen im Brennraum · mittel
- Verstopfte Einspritzdüsen · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2340.