U0417: Ungültige Daten vom Steuergerät der Feststellbremse empfangen
Was zu tun ist
Take this one seriously in both directions, because the dashboard may be wrong either way.
When you park, do not rely on the electric handbrake alone. Leave the car in park (or in gear on a manual), and turn the front wheels into the kerb on any slope. The car may say the brake is on when it is not, and unlike an old handbrake lever there is no way for you to check.
When you drive, watch for the brake being stuck partly on — a smell of hot brakes or burning, a feeling that the car is dragging or down on power, or the rear wheels being hot after a journey. If any of that happens, stop. Dragging brakes get hot enough to be genuinely dangerous.
If your rear brake pads have been changed recently, say so immediately. These systems have to be put into a service mode before the pads are done and reset properly afterwards, and one that was not put back correctly gives exactly this fault.
The usual cause is the wiring or connectors at the rear calipers, which sit in the road spray and salt, rather than the module itself.
Was dieser Code bedeutet
The electric park brake module is broadcasting data that cannot be accepted as true. See U0400 for the family's framing.
An electric park brake replaced a lever and a cable with two motors on the rear calipers and a module deciding when they clamp — and the value it publishes that matters is simply whether the brake is applied.
That single value has consequences in both directions, which is what makes this code serious.
A brake reported applied when it is not means a vehicle that may roll when parked, with the dashboard saying otherwise. The driver has no independent way to check — there is no lever position to see, no cable tension to feel — which is precisely the reassurance that was lost when the mechanism became electric.
A brake reported released when it is not means driving with the rear brakes partially clamped. That generates heat quickly, and the corpus records elsewhere what sustained brake drag does: overheated pads and discs, and on a long enough journey a genuine fire risk.
So the practical advice has to cover both, and it is concrete. When parking, use the vehicle's transmission park position and turn the wheels into the kerb on any slope, rather than relying on a brake whose state is not being reported reliably. And when driving, be alert to a burning smell, a smell of hot brakes, or the car feeling like it is dragging — any of those means stopping.
The failure is often in the caliper motors rather than the module, and their position is why: mounted on the rear calipers, under the vehicle, in the direct path of road spray and salt, with a short harness that flexes with suspension movement on every bump. Corroded connectors and chafed leads at the calipers are the ordinary findings.
One procedural point worth knowing: these brakes must be put into service mode before rear pads are changed, and a system that was not put back correctly afterwards produces exactly this. A code appearing right after rear brake work is that until shown otherwise.
Wahrscheinliche Ursachen
Hier anfangen
- Wasser in den Steuergerätestecker eingedrungen · mittel
- Korrodierter oder loser Stecker · einfach
- Kabelbaum beschädigt · mittel
Seltener
- Steuergerät der Feststellbremse defekt · Fachwerkstatt
- Eingang des empfangenden Steuergeräts defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0417.