U0059: Barramento de comunicação do veículo D — (+) alto
O que fazer
Disconnect the battery if the car is going to sit waiting for repair. That is unusual advice and there is a reason for it.
This fault has put battery voltage onto a network wire that every computer on that network is connected to — see U0005. And a network in that state cannot go to sleep, so the car stays awake and the damaging condition stays applied.
So the time the car spends sitting with the fault present is time those computers are being stressed. Disconnecting the battery stops both the drain and the exposure.
Be prepared for the repair to have two stages — the wiring fault found and fixed, and then whatever was damaged. A garage that reports further faults afterwards is not moving the goalposts.
The cause is nearly always something fitted after the car was built. A tracker, dashcam, alarm, stereo, light bar or tow bar, where a live feed was tapped next to the network wires or a self-stripping connector clipped onto the wrong one. Say what has been fitted, including by a previous owner — unplugging it and re-testing is quicker than any measurement.
O que este código significa
The positive line of vehicle communication bus D is being held high. See U0005 for the module-damage warning — battery voltage on a bus wire can destroy the transceiver in every module on that network.
And here it compounds with U0055's sleep argument in a way worth stating.
A bus held at battery voltage is both damaging and awake. So the vehicle is drawing current continuously while the condition persists — which means a battery that goes flat is not merely a symptom but a clock. The longer the vehicle sits with the fault present, the longer the modules are exposed.
Which produces a specific, unusual instruction: disconnect the battery while the vehicle waits for repair. That is normally advice about convenience. Here it limits the damage, and it is worth doing rather than leaving the vehicle to discharge itself over a week in a car park.
The cause is nearly always an added power feed — a live tapped beside the pair, a self-stripping connector on the wrong wire, a screw through a loom — and unplugging the device is quicker than any measurement.
Causas prováveis
Comece aqui
- Fiação em curto com a tensão · moderado
- Emenda de fiação malfeita em instalação de terceiros · moderado
- Instalação de alarme ou imobilizador de terceiros com defeito · moderado
- Fiação do barramento de dados danificada · moderado
Menos comum
- Chicote elétrico danificado · moderado
- Conexão de massa corroída · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre U0059.