P2430: Luftstromdrucksensor des Sekundärluftsystems — Stromkreis, Bank 1
Was zu tun ist
The car drives normally; cold-start emissions monitoring is affected, which matters at an emissions test. Worth knowing that this sensor is the one that checks whether air actually reaches the exhaust, as opposed to whether the pump is being told to run — so if secondary air faults have been chased electrically without resolution, this is the measurement that would have settled it.
Was dieser Code bedeutet
A fault in the circuit of the sensor that measures what the secondary air injection system is actually delivering on bank 1.
This sensor exists because the control circuit codes at P2257–P2260 cannot answer the question that matters. Those report whether the module can drive the pump and the valves. They cannot tell whether any air reached the exhaust — and on this system that gap is wide, because the characteristic failures are physical rather than electrical:
- The check valve seized, which blocks the path while the pump runs perfectly.
- The plumbing coked up, since it delivers air into an exhaust manifold and carbon accumulates at the junction.
- The pump spinning but not pumping, its impeller corroded by the exhaust moisture the check valve was supposed to keep out.
In every one of those the electrical side is faultless and no air arrives. The flow sensor is what closes that gap, which makes it more diagnostically valuable than its position in the numbering suggests.
A fault in the sensor itself therefore costs the ability to verify delivery, and the practical consequence is an incomplete monitor — the module cannot confirm the system works, so it reports that rather than a failure.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · einfach
- Luftmengensensor der Sekundärluft defekt · mittel
- Kabelbaum beschädigt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2430.