P2622: Ausgang der Drosselklappenstellung — Stromkreis hoch
Was zu tun ist
The engine responds to the pedal as usual, but the gearbox holds onto gears far too long, revs higher than it should in ordinary driving and drops a gear at the slightest press. Fuel consumption will be noticeably worse.
The distinction worth passing on is that the engine and the transmission disagree about what the throttle is doing, and the engine is the one that is right. A scan tool showing the two modules' throttle readings side by side makes that obvious in seconds, and it means no part of the throttle system or the gearbox needs replacing — the wiring between the modules does.
Was dieser Code bedeutet
The throttle position output circuit reads above its valid range — an open circuit, or a short to supply.
Where a short to supply holds the line at the top of its range, the mirror image of P2621 results: the transmission is told the throttle is wide open whatever the driver is doing. It therefore holds low gears far longer than necessary, delays upshifts, and downshifts on the lightest throttle — which feels like a car permanently in a hurry, revs high in normal driving, and shows up quickly in fuel consumption.
An open circuit gives the same picture as P2620: no signal, and a receiving module operating on a default.
As elsewhere in this family, the throttle body, pedal and position sensor are all demonstrably working, since the engine responds normally to the accelerator.
Wahrscheinliche Ursachen
Hier anfangen
- Leitung mit Spannung kurzgeschlossen · mittel
- Leitungsbruch in der Sensorleitung · mittel
- Korrodierter oder loser Stecker · einfach
Seltener
- Kabelbaum beschädigt · mittel
- Getriebesteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2622.