U0157: Kommunikationsverlust mit dem Informationszentrum B
Was zu tun ist
A second screen in the car has gone blank, and the car is entirely safe to drive.
There is one free check worth doing before it goes anywhere, and it will genuinely narrow things down.
Is the other display still working?
If it is, then the information is reaching the car perfectly well and only that one screen has a problem — its power supply or its connection. That is a much smaller job.
If both are blank, the fault is further back — something feeding both of them — and replacing either screen would be a waste of money.
Tell the garage which of the two you found. It saves them an hour and you the cost of it.
If your vehicle is a van, minibus or motorhome and the second screen is for body equipment, contact whoever converted it first. That wiring is usually theirs, and the fault is normally where their harness meets the vehicle's.
Was dieser Code bedeutet
A second information display has stopped being heard from. See U0156 for why a blank display is the honest failure, and U0458 for what a second one usually is.
Where two displays exist, silence localises the fault immediately in a way that bad data does not — and the check is free.
U0458's test is whether two working screens agree. Here the test is simpler: which one is blank?
- One blank, the other working. The fault is that display, its supply or its connection. The information reaching the vehicle is fine, because the other screen is showing it — which rules out every module that supplies the data and narrows the search to one unit.
- Both blank. The fault is upstream of both: a shared supply, the gateway between them and the rest of the vehicle, or the network itself. Replacing either display is wasted money.
That distinction is worth making before the vehicle goes anywhere, because it is the difference between a connector and a network investigation.
On a converted or commercial vehicle there is a further possibility worth eliminating first. A second display fitted for body equipment or fleet use is often the converter's work rather than the manufacturer's, so the join between the two harnesses is where the fault lives — the U0148 argument.
Everything else at U0156 applies, including the warning about second-hand display modules and stored mileage.
Wahrscheinliche Ursachen
Hier anfangen
- Sicherung durchgebrannt oder Versorgung ausgefallen · einfach
- Korrodierter oder loser Stecker · einfach
- Datenbusleitungen beschädigt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0157.