Aller au contenu

U0004 Élevée Générique / SAE

U0004: Bus de communication CAN haute vitesse — (+) bas

WhatsApp Telegram X E-mail

Ne continuez pas à rouler

The car will probably not start, and the dashboard may be dead or lit with warnings from everything at once. That is one damaged wire, not a dozen failed computers.

The two wires that carry your car's internal network are being held down by a short to the bodywork, so no messages can get through.

Two things are worth telling the garage, because they save real time.

Has anything been fitted to the car — a tracker, dashcam, alarm, stereo, tow bar, insurance box? An added earth connection or a screw through the loom next to the bus wires is a common cause, and unplugging the device to re-test is far quicker than stripping a dashboard.

And did the fault come and go before it became permanent? That is typical of a wire rubbing through against the bodywork, and it tells a technician to move the loom by hand rather than to reach for a meter.

The car will need recovering. Do not let computers be replaced on the strength of the long list of faults — they are almost certainly all fine.

Ce que signifie ce code

The positive line of the high speed data bus is being held low. See U0003 for the pair, the resistance test and why one damaged wire stops the whole network.

This one has a voltage signature that identifies it in seconds, and it is worth knowing because it distinguishes a short from an open without disturbing anything.

At rest, both bus wires sit at about 2.5 volts. When a message is sent, CAN-H rises to roughly 3.5 and CAN-L falls to roughly 1.5 — symmetrically, which is the whole point. A CAN-H line sitting at zero and never moving is shorted to earth.

Where that happens is nearly always mechanical rather than electrical. A conductor chafed through against the body, a bracket, or an edge of a panel — which is why the fault frequently follows the loom's route rather than any component, and why it is often intermittent before it is permanent.

So the test that finds it is physical: move the loom. A bus that recovers when a section of harness is lifted or flexed has told you where to look, and that is faster than any meter on a fault that is currently present.

One thing to check before searching the vehicle's own wiring. An aftermarket installation that tapped an earth beside the bus pair, or ran a screw through the loom, is a common cause — and it is much quicker to unplug a tracker or a dashcam and re-test than to strip a dashboard.

Causes probables

Commencez ici

Moins fréquent

Symptômes

Composants concernés

Des informations, pas des instructions

CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.

Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.

Expérience de la communauté

Soyez le premier à en faire le compte rendu

Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.

Ce qui rend un compte rendu utile :

  • La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
  • Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
  • Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.

Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de U0004.