U0036: Kommunikationsbus des Fahrzeugs A — (−) kurzgeschlossen mit Bus (+)
Was zu tun ist
Expect a set of systems to have stopped completely rather than working badly, and possibly a garage saying their diagnostic tool cannot connect.
The two wires carrying this network are touching each other. Because they carry the same message in opposite directions, joining them cancels it entirely — so the network stops rather than degrading.
There is one useful thing about this particular fault: it can be confirmed without any manufacturer data at all. A dead short reads close to zero ohms across the pair, and that is wrong on every network there is. Most measurements on a lettered network need the manufacturer's figures first; this one does not.
Two wires twisted together only touch for physical reasons, and the list is short. A loom crushed by a panel, a bracket or a fixing. A screw put through the harness during a repair or an accessory installation. Water bridging a connector. Rodents.
Do not let computers be replaced — they are almost certainly all fine.
Was dieser Code bedeutet
The two lines of vehicle communication bus A are shorted together. See U0009 for why joining a differential pair cancels the signal completely, and for the short list of physical causes.
This is the one fault on a lettered bus that can be confirmed without identifying the network first, and that is genuinely useful.
U0028 explains that nothing about a lettered bus can be judged until it is identified — its resistance figure, its acceptable error rate, even which modules are on it. A dead short is the exception. Near zero ohms across a pair is wrong on every network there is, whatever its speed, medium or terminated value.
So this fault can be proved with a meter and no reference data, which shortens the diagnosis considerably. Identifying the network is still needed to find the wiring, but not to establish what is wrong.
And the causes remain physical and short: a loom crushed by a panel, a bracket or a fixing; a screw or self-tapper put through a harness during a repair or an installation; water bridging a connector; rodent damage that stripped both conductors at one point.
Wahrscheinliche Ursachen
Hier anfangen
- Busleitungen miteinander kurzgeschlossen · mittel
- Kabelbaum beschädigt · mittel
- Wasser in den Stecker eingedrungen · mittel
- Datenbusleitungen beschädigt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0036.