P24D6: Drucksensor oder -schalter B des Kraftstoffverdunstungssystems — Stromkreis, Bereich/Funktion
Was zu tun ist
This will not affect how the car drives. It concerns the system that stops petrol vapour escaping from the tank, not anything to do with running.
It does matter for the MOT. While it is stored the vehicle cannot complete its evaporative emissions self-check, and an incomplete monitor can fail the test by itself — so get it looked at with time in hand rather than the week before.
Check the fuel filler cap is properly tightened, and mention if it is old or its seal looks perished. It is part of the sealed system being tested and a common contributor to related faults.
Mention any smell of fuel, which would point at a genuine leak alongside the sensor fault and raises the priority.
Was dieser Code bedeutet
The second evaporative system pressure sensor or switch is reporting a value that does not fit the conditions.
The evaporative system exists to stop fuel vapour reaching the atmosphere, holding it in a charcoal canister and drawing it into the engine to be burned. Pressure sensors are how the vehicle proves that system is sealed.
Sensor B is the second of at least two, which is what makes range/performance detectable at all: the module has another measurement to compare against. A single sensor drifting slowly is very hard to catch; two sensors that should agree and do not are conclusive.
The strongest evidence is a disagreement at rest. After the vehicle has stood, every pressure in the system should equalise to atmospheric. Two sensors that still disagree at that point have settled the question, and no running data is needed.
This code blocks the evaporative readiness monitor, so the practical consequence is an MOT problem rather than a driving one.
Check the plumbing before the sensor. These lines are thin plastic, they run under the vehicle, and a kinked, split or blocked hose isolates a sensor from the pressure it is meant to be measuring — which reads exactly like a failed sensor and costs a fraction as much to put right.
Wahrscheinliche Ursachen
Hier anfangen
- Tankdrucksensor defekt · mittel
- Tankentlüftungsschlauch verstopft oder geknickt · einfach
- Korrodierter oder loser Stecker · einfach
Seltener
- Wasser in den Stecker eingedrungen · einfach
- Leckdiagnosepumpe des Tanksystems defekt · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24D6.