U0115: Kommunikationsverlust mit dem Motorsteuergerät B
Nicht weiterfahren
Expect the engine to run very badly or not at all.
If the car has an engine large enough to use two control modules — commonly a V8 or larger — losing one silences an entire bank of cylinders at once. That feels and sounds catastrophic, like a major mechanical failure, and it usually is not: compression, camshafts and timing can all be perfect while one module has simply stopped talking.
The distinguishing feature is that it arrived all at once and affects exactly one side of the engine. Mechanical failures develop, and rarely respect that boundary so precisely. Say so if that is what happened.
These modules are expensive and have to be programmed to the vehicle, so ask what has been checked before one is ordered — its power supply, its earth, its connectors and the network wiring, as at U0100.
Was dieser Code bedeutet
A second engine control module has stopped being heard from. The general reasoning is at U0100 and applies unchanged.
A vehicle has two engine control modules for one of two reasons, and which applies changes what this code means.
- A large engine managed in halves. Some V-configuration and larger engines use one module per bank, sharing the work and halving the number of long injector and coil circuits each has to drive. Losing one costs half the engine: it runs, badly, on the cylinders the surviving module controls, which presents as a severe misfire across one bank rather than as a no-start.
- A master and a secondary module, where the second handles a defined subsystem. Losing it removes that subsystem while the engine continues.
The first case is the one worth recognising, because a whole bank silent looks like a catastrophic mechanical failure and is not. Compression is fine, the camshafts are fine, the timing is fine — one module has stopped receiving or sending, and every cylinder it commands has gone quiet together. A misfire confined exactly to one bank, arriving all at once rather than developing, is a strong pointer to this rather than to anything mechanical.
The causes are the family's usual ones, and the argument at U0100 about not replacing a module before checking its supply, its earth and the bus applies with more force here, because these modules are expensive and require programming.
Wahrscheinliche Ursachen
Hier anfangen
- Versorgung oder Masse des Steuergeräts ausgefallen · mittel
- Datenbusleitungen beschädigt · mittel
- Korrodierter oder loser Stecker · einfach
- Sicherung durchgebrannt oder Versorgung ausgefallen · einfach
Seltener
- Ein anderes Steuergerät zieht den Bus auf Masse · Fachwerkstatt
- Motorsteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0115.