P2444: Pumpe des Sekundärluftsystems — Klemmt eingeschaltet, Bank 1
Was zu tun ist
Worth attending to quickly rather than at the next service. Expect poor economy, a rough idle and possibly an audible pump running when it should be silent. Two things are being damaged meanwhile: the pump itself, which is built for about a minute of running per cold start and will burn out if held on, and the catalytic converter, because the extra air makes the sensors read lean and the engine is over-fuelled in response. Ask for the pump relay to be tested first — a relay with welded contacts holds the pump on regardless of what the module wants, and it is much the cheapest of the possible causes.
Was dieser Code bedeutet
The bank 1 secondary air pump is running when it should not be.
This does everything the stuck-open valve at P2440 does, and adds two problems of its own.
The shared consequence first: air pumped into the exhaust outside the cold-start window makes the oxygen sensors report a lean mixture that is not there, so the module over-fuels and the engine runs genuinely rich. The full argument is at P2440 and applies unchanged.
What is specific to the pump running is that the pump is not built for it. These are simple electric air pumps rated for a short burst — thirty to ninety seconds once per cold start, which over a day amounts to a couple of minutes of running. Asked to run continuously, one will overheat and destroy itself, usually within hours rather than weeks. So this code has a deadline of its own: the longer it stays unrepaired, the more likely the fault becomes a pump replacement as well.
And it draws current the whole time. On a vehicle left parked with the pump running, that is a flat battery; on a vehicle in use, it is a constant load the charging system was not asked to carry.
The cause is very often the relay rather than the pump or the module. A relay switching a heavy current in short bursts is exactly the duty that pits and eventually welds contacts, and a welded relay holds the pump on regardless of what the module commands. That is a cheap part, and it is worth testing before anything larger is considered — including before the module is suspected of commanding the pump wrongly.
Wahrscheinliche Ursachen
Hier anfangen
- Relais der Sekundärlufteinblasung defekt · einfach
- Relaiskontakte verschweißt · einfach
Seltener
- Leitung mit Spannung kurzgeschlossen · mittel
- Umschaltventil der Sekundärluft defekt · mittel
Selten
- Motorsteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2444.