Zum Inhalt springen

Die Referenzinhalte erscheinen auf Englisch, solange ihre Übersetzung entsteht.

Belt CVT (continuously variable)

CVT · 1958–present

WhatsApp Telegram X E-Mail

Auch bekannt als: cvt, belt cvt, push-belt, variomatic, continuously variable transmission

The architecture, for the cars whose specification says only CVT and names no unit. The maker-specific pages in this catalogue — Jatco's, Aisin's, Subaru's, Toyota's — carry the part numbers; this one carries what they all share.

A belt CVT has two variable-width pulleys and a steel push-belt between them, and the ratio changes because the pulleys close and open. The whole drive depends on hydraulic pressure clamping those pulleys onto the belt — there is no clutch pack holding a gear, no synchro, and nothing mechanical that stays engaged on its own.

That single fact orders every symptom. The failure sequence is the same on every belt CVT ever built:

  1. Aged fluid loses clamping pressure before it loses anything else. Felt as a slip under acceleration — the engine rises and the car does not — most obviously uphill or overtaking.
  2. The pulley faces glaze where the belt has been slipping against them.
  3. The belt marks them permanently, and at that point the unit is replaced rather than repaired.

The first stage is a fluid service and the last is a new transmission, which is why CVT fluid intervals are real in a way that a torque-converter automatic's are not. The fluid is not a generic ATF and is not interchangeable between makers — Nissan's NS-2/NS-3, Toyota's CVT-FE, Subaru's CVTF, Honda's HCF-2 are different fluids for different clamping systems.

A shudder at light throttle at a steady speed is usually the torque converter's lock-up clutch, not the belt — most CVTs have one — and that distinction is worth making before anything expensive is contemplated.

Towing, sustained hills and stop-start traffic age the fluid far faster than the odometer suggests.

Three different things are called a CVT in a specification and only one of them is this. A hybrid e-CVT is a planetary power split with two motors and no belt at all; an electric car's single-speed reduction is a fixed gear with no ratio to vary. Neither can have any of the faults above, and both have their own pages here.

Fahrzeuge mit diesem Getriebe

190 Generationen. Nur wenn eine Quelle Modell und Generation zusammen nennt — ein Getriebe wird weit häufiger als Produkt dokumentiert denn als Ausstattung, deshalb ist diese Liste bewusst kürzer als die Wirklichkeit.

Mazda

Volkswagen

Information, keine Handlungsanweisung

CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.

Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.

Erfahrungen der Community

Schreiben Sie den ersten Erfahrungsbericht dazu

Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.

Was einen Bericht lesenswert macht:

  • Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
  • Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
  • Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.

Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu Belt CVT (continuously variable).